| |
Sidewalk
Swinger™
User Guide
-
Install
anti-slip feet by pushing feet into holes on bottom
of Uprights and pressing drive pin in completely
to lock foot in hole.
-
Attach
Cross Tubes to Uprights using Cross Tube Inserts (small
bushings) and Truss Head Bolts. Put Tube Insert into
Cross Tube (small end in), slide Cross Tube into deep
recess of Upright, insert Truss Head Bolt and tighten.
Repeat until both Cross Tubes are in place.
-
Measure
13 1/2" - 13 3/4" (35cm) down from top of
sign face and mark edge. This is where the Cross Rod
will slide through sign.
-
Attach
sign to Uprights using Sign Holder Bushing, Knob Bushing,
Threaded Cross Rod and Knobs.
Best
Method:
-
Attach
Knob to one end of Threaded Cross Rod.
-
Slide
on Knob Bushing, large flat face against Knob.
-
Insert
Threaded Cross Rod into hole at top of Upright from
outside edge.
-
Slide
on Sign Holder Bushing, "U" Channel facing
in .
-
Insert
Threaded Cross Rod into sign face at mark 13 1/2"
- 13 3/4" (35cm) from top.
-
Slide
on Sign Holder Bushing, "U" Channel facing
sign.
-
Insert
Threaded Cross Rod into hole at top of Upright.
-
Slide
on Knob Bushing, large flat face out.
-
Tighten
Knobs firmly making sure sign face sits in "U"
Channels.
-
Decorate
sign face before attaching to sign base. Keep design
simple for maximum impact.
-
To
transport, tip sign on one Upright and hold from other
Upright. Sign is only 24" wide and will fit through
any doorway.
-
Swinger
Sidewalk Signs are designed for winds up to 20-25
mph. In the event of high winds bring sign inside,
put sandbags on crosstubes, or add sand to ballast
port on inside of Upright by prying out cap
|
|
 |
