BANNER POLE & WINDOW BANNER HOLDER INSTRUCTIONS

BANNERS
• Assemble Super Sucker™ by screwing Pole onto threaded stud on Base.
• Slide hemmed and decorated banner over Pole.
• Screw End Cap onto end of Pole.
• Attach Super Sucker™ to clean window with flat bracket facing up by flipping the Lever.
• Use multiple Super Suckers™ for greater impact.

SIGNS
• Only use lightweight sign substrates (4mm corrugated plastic is ideal).
• Decorate sign and punch 3 holes in top of sign 1/2” - 1” from top and at least 1” from edges.
• Install 3 Pear Clips on sign, small end in hole.
• Slide first O Ring onto end of Pole.
• Slide sign with 3 Pear Clips onto Pole, large end over Pole.
• Slide second O Ring onto Pole and position so sign is centered.
• Screw End Cap onto end of Pole.
• Attach Super Sucker™ to clean window with flat bracket facing up by flipping the Lever.

INSIDE MOUNTING
• Attach 2 Super Suckers™ to clean window, flat bracket facing up, by flipping the Lever.
• Make sure Super Suckers™ are level and are spaced wider than the banner.
• Attach banner to Super Suckers™ with bungee cords, rope, etc. Pull firmly but don't over tighten.
• For diagonal mounting use 4 Super Suckers™.

OUTSIDE MOUNTING
• Attach top 2 Super Suckers™ to clean window, flat brackets facing up, by flipping the Levers.
• Make sure Super Suckers™ are level and are spaced wider than the banner.For diagonal mounting raise one Super Sucker™ to achieve desired angle.
• Attach top of banner to Super Suckers™ with bungee cords, rope, webbing, etc. Pull firmly but do not over tighten.
• Attach bottom 2 Super Suckers™ to clean window, flat brackets facing down, by flipping the Levers.
• Attach bottom of banner to Super Suckers™ with bungee cords, rope, webbing, etc. Pull firmly but do not over tighten.

HELPFUL HINTS
• Decorate sign face or banner before attaching to Pole or window. Keep design simple for maximum impact.
• Bungee cords work best on banners with grommets or “D” rings and keep an even tension.
• Super Sucker™ can be mounted to any flat, clean, smooth, non-porous surface.

• Super Sucker™ universal sign and banner holders are designed for winds up to 25 mph. In the event of higher winds remove unit from window and bring inside. • Super Suckers™ should be removed at night or when the business is closed to minimize vandalism or theft. Attach sign or banner to inside of window for full time exposure.

CLICK HERE TO DOWNLOAD PDF INSTRUCTIONS WITH DIAGRAMS