| |
1-Rail™
User Guide
- Determine
length of 1-Rail™ required and cut as needed.
- Drill
three 3/16" holes in each 1-Rail™; 1 hole in the center
and 1 hole 8" in from each end.
- Mark
a level line at the desired height of 1-Rail™.
- Place
1-Rail™ in position on wall and mark hole positions on wall.
Drill 3/16" hole in wall, insert anchor and screw rail to
wall. If using multiple 1-Rails™ be sure to use Joiner between
adjacent rails.
- Insert
4 Nut/Spacer/Thumbscrew assemblies in each 5' length of 1-Rail™.
- Insert
End Caps into 1-Rail™ for a finished look.
- Attach
banner or mounted graphic to 1-Rail™ using Thumbscrews, without
spacer, before sliding to desired position and tightening finger
tight. For hanging frames or suspending graphic panels use spacer
under the head of the Thumbscrew.
- 1-Rail™
Thumbscrews can be repositioned as needed to display signs, banners,
posters, frames and graphics, etc.
Note:
Leave Thumbscrews
and Spacers tightened in Nuts on 1-Rail™ to prevent loss
or store in a safe location for future use.
|
|
 |
